Who Can Fix Pilot Light Of The Stove

Older gas appliances may have pilot lights that provide instant ignition when the gas is turned on. The pilot light is a small open flame that is fed by a steady flow of gas.

Problems occur when the gas flow is obstructed or misdirected, or when the pilot is blown out. In newer appliances, ignition may exist achieved past a sparking device or a glow bar instead of a pilot lite. In furnaces and water heaters, and in some ranges and dryers, the airplane pilot light is accompanied past a safety device called a thermocouple -- a oestrus sensor that turns the gas off if the pilot flame is extinguished. Newer gas appliances accept igniters that start the airplane pilot light equally needed.

Caution: Some older appliances may non accept a condom device to plow the gas off when the pilot is extinguished. With whatever gas-fired apparatus, if a strong smell of gas is present, practice not effort to relight the pilot or turn the appliance on, or turn whatever lights on or off. Get out of the house, leaving the door open, and phone call the gas company or the fire department immediately to written report a leak.

Pilot Lights

A correctly adapted pilot flame is steady and blue, and stands betwixt i/4 and 1/ii inch high. If the flame goes out repeatedly, it may be getting likewise footling air; if it's yellow at the tip, it'southward getting too much air. To correct either status, turn the pilot adjustment spiral slightly, equally directed by the manufacturer. When a pilot goes out, relighting it is simple:

Step one: If there is a gas valve at the airplane pilot, turn the valve to the OFF position and look at to the lowest degree three minutes to allow any built-upwardly gas misemploy. After three minutes, turn the valve to the Pilot position. If in that location is a condom or reset push, push the push, and keep it depressed.

Step ii: Hold a lighted match to the pilot orifice and turn the gas valve to the ON position. Then, when the pilot is burning brightly, release the reset push button. If at that place is no reset button or gas valve, simply concord a lighted match to the airplane pilot orifice.

Step 3: If the pilot flame won't stay lit subsequently several tries, information technology should be adjusted past a professional. Don't attempt to adjust the machinery or tamper with the gas line.

©2006 Publications International, Ltd. **To adjust the pilot flame, turn the adjustment screw** **on the gas line, as directed past the range manufacturer.**

Thermocouples

If the apparatus has a thermocouple, the problem may be a faulty thermocouple. The thermocouple, which operates every bit a safety device, turns the gas supply off when the pilot light goes out. Information technology consists of a heat sensor continued to a solenoid; when the sensor is non heated by the pilot flame, the solenoid closes the gas supply line. When a thermocouple fails, the pilot light won't stay lighted. A burned out or broken thermocouple should exist replaced. To replace a thermocouple:

Step 1: Unscrew the copper pb and the connection nut inside the threaded connectedness to the gas line.

Pace 2: Under the mounting bracket at the thermocouple tube, unscrew the bracket nut that holds the tube in place.

Stride 3: Insert a new thermocouple into the hole in the subclass, steel tube facing up and copper lead downwardly.

Step 4: Nether the bracket, screw the bracket nut over the tube. Push the connection nut to the threaded connectedness where the copper atomic number 82 connects to the gas line. Make sure the connection is clean and dry.

Footstep 5: Screw the nut tightly into place, but do non overtighten it. Both the bracket nut and the connection nut should be simply a little tighter than if hand-tightened.

In our final section, we will conclude our discussion of repairing major appliances with a detailed test of -- of class -- motors. Continue reading to notice out how to maintain and repair ane of the well-nigh vital components of any machine.